2-30
CONTROLS
DPF MANUAL REGENERATION/INHIBIT
SELECT SWITCH
SWITCHES
ECO/POWER MODE SELECT SWITCH
• When the ECO symbol side of the switch is
pressed, the ECO mode indicator lamp in
the instrument cluster lights up.
The engine RPM and output are set to
economically optimal values to improve the
fuel economy.
• STD mode: When the neutral position of
the switch is pressed, the ECO or Power
mode indicator lamp goes out.
The engine speed is specified by the
throttle lever and the throttle pedal.
• When the PWR symbol side of the switch
is pressed, the Power mode indicator lamp
in the instrument cluster lights up.
The maximum engine output is obtained.
To cancel, either set to the neutral position
or to the opposite mode.
Refer to “Instrument cluster” on page 2-14.
• The DPF and the exhaust gas emitted
from the exhaust line can be very hot
while the engine is running or the
regeneration is under way, as well as
immediately after the engine is stopped.
Be careful not to accidentally touch
them; doing so could cause burns.
• Do not perform the DPF regeneration if
the machine is surrounded by flammable
items such as plants, trees, dry grass,
wastepaper, oil and waste tires. There is
a risk of fire due to the high-temperature
exhaust gas emitted from the DPF.
• Do not perform the DPF regeneration in
poorly-ventilated indoor spaces, as
smoke could be generated during the
DPF regeneration or carbon monoxide
poisoning could result.
• Do not perform regeneration when the
engine hood is open. There is a risk of
fire due to the high-temperature exhaust
gas emitted from the DPF.
To Next Page
Loading...
Need help?
General
