73
6 Internet security
DMS3-CTC-25-420 v1.0. Copyright © 2017 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
6.1 Site blocking
Introduction
The site blocking function allows you to block access to specific websites.
Blocking sites
Proceed as follows:
1 Browse to the DGA4130 web interface.
For more information, see “4.1.1 Accessing the DGA4130 web interface from your local network” on page 40.
2 Click Parental Controls. The Site Blocking page appears.
3 If needed, switch Enabled to and click Save.
4 For each site that you want to block, proceed as follows:
a Click Add New Site. The DGA4130 adds a new row to the table.
b Under Site, type the URL of the site (e.g. facebook.com).
c Under Device, type either
• The IP address of the device for which the exception is valid (for example, dad’s computer).
• All (with captital A) if you want this exception to be valid for all devices.
d Click (add). The site is now blocked.
5 Click Close.
6 Parental control is now active. When a user tries to access a blocked website, he will be redirected to a page that informs
him that access to this website has been blocked.
To only block websites at specific times or days (e.g. no access to facebook.com after 22:00), use Access Control
instead. For more information, see “6.2 Access control” on page 74.
You can also type in (a part of) the host name of the device. The DGA4130 will then display a list of devices
with such a host name. If you then click one of the results, the DGA4130 will insert the corresponding IP
address.
To Next Page
Loading...
Need help?
General
