69
5 Content and Printer Sharing
DMS3-CTC-25-420 v1.0. Copyright © 2017 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
5.2 Printer sharing
Introduction
A DGA4130 USB port allows you to share your USB printer in your local network. This way everyone in your network can
use the same printer without having to buy an expensive network printer.
Requirements
The samba server must be enabled on the DGA4130 (this is the default setting).
For more information, see “Customizing the content sharing settings” on page 66.
Procedure
Proceed as follows:
1 Connect your USB printer to the DGA4130. For more information, “5.2.1 Connect your USB printer to the DGA4130” on
page 69.
2 Configure the printer sharing service on your DGA4130.
For more information, see “5.2.2 Enable the printer sharing service on your DGA4130” on page 70.
3 Install the printer on your computer.
For more information, see “5.2.3 Installing the printer on your computer” on page 71.
5.2.1 Connect your USB printer to the DGA4130
Plug the USB cable of your printer in (one of) the USB port(s) of your DGA4130.
To Next Page
Loading...
Need help?
General
