52
M_T08_EN_B
Menu: Edit le
Movement speed
Used to determine the speed of the stylus when moving without marking.
This value is expressed as a percent. It must be between 1% and 100%, with increments of 1%. The default
value is 20%.
The displacement speed and the marking speed are set using the same cursor (depending on version: Impact).
This value must be between 1 and 10.
Marking speed
Used to determine the speed of the stylus during the marking.
This value is expressed as a percent. It must be between 1% and 100%, with increments of 1%. The default
value is 20%.
The faster the marking, the lower the quality. A very high quality marking requires a slow marking speed.
The displacement speed and the marking speed are set using the same cursor (depending on version: Impact).
This value must be between 1 and 10.
Marking quality (depending on version)
This value is expressed as a percent. It must be between 0% and 100%, with increments of 1%. The default
value is 100%.
This value guarantees the best quality for a given speed. For faster marking, when quality is not the priority,
this value can be reduced. In all other cases, it is recommended to use the default value. This is especially
important for automated reading applications.
Dot density per millimeter
This value is expressed in points per mm. It must be between 0.5 and 3, with increments of 0.1. The default
value is 2.0.
Allows a continuous stroke font or a logo to be marked (electromagnetic version only).
To Next Page
Loading...
Need help?
General
