90
M_T08_EN_B
Menu: Settings
5. Menu: Marking settings
Used to:
• select the "O-limits control" option.
• convert the units into inches.
• Off-limits control
This option is activated by default (Impact eZ)
If the marking is o-limits, the program sends an error message.
The calculation time is extended and the total cycle time is longer.
When the o-limits control is deactivated, the stylus may run into the mechanical stop if the text is too long or
if the coordinates are incorrect. However, calculation of the marking coordinates is faster, therefore the total
cycle time is shorter.
Usetheo-limitscontrolwhenpreparingorupdatingamarkingle,thendeactivatethis
option.
• Conversion of the units into inches
The marking program works in both millimeters and inches. All values pertaining to length are expressed in the
chosen unit. To change from millimeters to inches, tick the corresponding box.
Changing from mm to inches automatically converts all values contained in the marking les.
To Next Page
Loading...
Need help?
General
