GPIB
4-36
370B User Manual
Table 4-9: Front Panel Controls (Cont.)
Command DefinitionLinkArgument
STEP GENERATOR COMMAND GROUP
CONfig BSGen
BOPen
BSHort
EOPen
ESGen
BCOll
Sets Configuration mode.
CONFIG <mode>
<mode> ::= BSG|BOP|BSH|EOP|ESG
BSG ::= BASE STEP GEN & EMITTER COMMON
BOP ::= BASE OPEN & EMITTER COMMON
BSH ::= BASE SHORT & EMITTER COMMON
EOP ::= BASE COMMON & EMITTER OPEN
ESG ::= BASE COMMON & EMITTER STEP GEN
BCO ::= BASE COLLECTOR SUPPLY & EMITTER COMMON
CONfig? Reports configuration
CONFIG <mode>
<mode> ::= BSGEN|BOPEN|BSHORT|EOPEN|ESGEN|BCOLL
MEASUREMENT COMMAND GROUP
MEAsure REPeat
SINgle
SWEep
Selects measurement mode.
MEASURE <mode>
<mode> ::= REPEAT|SINGLE|SWEEP
MEAsure? Reports measurement mode:
MEASURE REPEAT|SINGLE|SWEEP
OTHER COMMANDS
ACQuire ENVelope
NORmal
AVG
VERt
HORiz
Sets the acquisition mode.
ACQuire? Response with the acquisition mode:
ACQUIRE <mode> :[<val>]
<mode> ::= ENVELOPE|NORMAL|AVG
<val> ::= VERT|HORIZ
MAG ON
OFF
Turns X10 Magnification on or off.
MAG? Response with the magnifier mode:
MAG <mode>
<mode> ::= ON|OFF
RECall <NR1> Recall front panel setup data in the memory location stated by argument.
RECALL <index>
<index> ::= 1|2|...|80
SAVe <NR1> Store the displayed setup data in the memory location stated by argument.
SAVE <index>
<index> ::= 1|2|...|80
To Next Page
Loading...
General