" !
" !
6Ć25
Perform this procedure only if replacing a failed or damaged menu
flex circuit with a fresh unit from the factory. (Removal of the circuit
will destroy it.)
! ! Ċ This procedure requires that the
following procedures be performed first:
H Rear Cover Removal
H Cabinet Removal
H Front Trim Removal
H A62 Front Panel Module Removal
1. Pull the flex circuit away from the front of the main chassis. (It is held on
by its sticky backing.) See Figure 6Ć13.
2. Wipe the front of the chassis using isopropyl alcohol and a clean, lintĆ
free cloth. Let dry. (Some adhesive from the flex circuit you removed will
be left on the front of the chassis. This is normal.)
! %$! # ! "
3. Find the score line in the adhesive backing and peel the backing off of
the menu flex circuit.
NOTE
DO NOT touch the contacts on the menu flex circuit with your bare
fingers. You should wear clean cloth gloves that are free of lint
when installing the menu flex circuit on the front chassis.
! # !
To Next Page
Loading...
Need help?
General
