$ #
4Ć13
!"!
This subsection contains procedures to verify that the TAS 465 Analog
Oscilloscope performs as warranted.
The procedures are arranged in three logical groupings:
$ and . They check all the characteristics
that are designated as checked in Section 1, . (The checked
characteristics appear in type under in
Section 1.)
These procedures # the confidence level provided by the %
in this section.
The tests in this subsection comprise an extensive, valid confirmaĆ
tion of performance and functionality when the following requireĆ
ments are met:
H The cabinet must be installed on the oscilloscope.
H The "% show no failures.
H You must have completed the ! ,
beginning on page 4Ć9.
H The oscilloscope must have an operating warmĆup period of at least
20 minutes at an ambient temperature between -10_ C and +55_ C.
H You have set the and controls for nominal viewĆ
ing levels.
H You have set the delayed sweep intensity to "!"% % in
the Utility Configure menu.
" " Ċ Read ! that start on page 4Ć1.
If you are not familiar with operating this oscilloscope, read ! in
Section 2 before performing these procedures.
These procedures use external, traceable signal sources to directly check
warranted characteristics. Table 4Ć1 lists the required test equipment.
!"!
#!"!
#" #
To Next Page
Loading...
Need help?
General
