w
TEMPTRONIC
CrJoFOEATlPt~'
Conducting
Tests
3-1
1.1
Overview
Rev
A: 0611
5/98
System Operation
TP04100A Interface
&
Applications
In Program Operation Mode the operator can conduct tests in two temperature control modes:
1.
Main Air mode:
factory set default, which uses the main airstream temperature at th
nozzle outlet
e Thermal Wand
2.
DUT mode:
which uses the DUT temperature as primary control, and requires a temperature sensor be
interfaced directly to the DUT
Testing procedures for the two temperature control modes are presented in this section.
A
test will run, however, only if its related test setup parameters have been properly preset (see Section 3-12,
Setting Up Tests).
The next paragraphs describe the Program Operation mode for testing by:
1.
Cycling
from two up to 10 setpoints, by using the Cycle function on the
Program Operation Screen.
2.
Ramping and soaking
for the cycling sequences
as
defined using the
Program Test Setup Screen.
To test from a
manually selected setpoint,
using the
Manual Operation Screen,
see the
TP04100A
Operator's
Manual.
As the Main Air mode
I)
is factory set, and
2)
the screen commands of DUT mode are variations of the default
Main Air mode screen commands:
FAMILIARITY WITH THE DEFAULT "Air" MODE SCREENS IS RECOMMENDED
BEFORE ATTEMPTING TO
OPERATE
IN DUT MODE.
For a flow diagram of the thirteen TP04100A screens, see the Screen Tree in Section
3-17
on page3-48.
Page
3-23
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
