96
router.
Metric: Enter a number in the Metric field. This stands for the number of routers between your network and the
destination.
Apply /Save: Click to apply and save your settings.
_________________________________________________________________________________________________
NOTE
1. Destination IP address cannot be on the same IP segment as WAN or LAN segment as the router.
2. Only configure additional static routes for unusual cases such as multiple routers or multiple IP subnets located on
your network. Wrong static routes may lead to network failure.
3. For system created route, the “Remove” checkbox is disabled.
_________________________________________________________________________________________________
4.2.9 DNS
DNS Server (Static DNS)
The DNS server translates domain names to numeric IP addresses. It is used to look up site addresses based on their
names. If the DNS server works incorrectly, Internet access will be blocked.
DNS server is configured when you are setting up your Internet connectivity. So, you do not have to finish DNS server
setup here unless your network works false.
For IPv4
① Click Advanced Setup > DNS > DNS Server, and enter the screen below.
To Next Page
Loading...
Need help?
General
