Operation
EN DE
In order to use the display of the battery charge state display and the range
remaining, proceed as follows:
Before starting with a fully charged battery
1. Set the state of charge to 100 %, in accordance with the accelerator lever
manual.
ADVICE
Press the button only when the battery is fully charged. The on-board computer
calculates on the basis of the latest stored state of charge if the charge state is
not set to 100 %.The on-board computer calculates on the basis of the latest
stored charge state if the charge state is not set to 100 %.
6.3 Travel mode
6.3.1 Starting a trip
ADVICE
■
If there is visible damage to components or cables, the Cruise system must
not be switched on.
■
Ensure that all people on board wear a life jacket.
■
Before starting, attach the lanyard of the Emergency Stop to the skipper’s
wrist or life jacket.
■
The state of charge of the battery must be checked at intervals while on the
move.
ADVICE
During breaks in a trip, if there are swimmers near the boat while at anchor:
remove the Emergency Stop magnetic chip in order to avoid unintentionally
starting the Cruise system.
Starting the motor
1. Switch the motor on by pressing the On/Off button (1) for one second.
2. Place the Emergency Stop magnetic chip on the accelerator lever.
3. Move the accelerator lever from the neutral position to the desired position.
Fig. 51: Throttle
page 89 / 113
To Next Page
Loading...
Need help?
General
