1 BEFORE USING EQUIPMENT
10 BASIC Menu for the Copier Function
Equipment status indication area
The equipment status indication area shows the following information:
1. Receiving tray indication ( P.35)
This shows the tray to which copied paper exits.
2. [EXIT TRAY] button ( P.35)
This is for switching receiving (exit) trays.
3. Drawer buttons ( P.55)
These show the size of paper, amount of paper remaining in each drawer and the paper type set for the
drawer. When you want to use a particular drawer, press the corresponding button.
The amount of paper remaining in each drawer is displayed as follows. Use it as a rough guide since
the detection of the remaining paper may vary depending on the paper type.
* Approx. 100 sheets of plain paper recommended by TOSHIBA
4. [BYPASS FEED] button ( P.36)
When this button is pressed with paper set in the bypass tray, it will be selected as the paper source.
5. Paper type on the bypass tray ( P.36)
This shows the type of paper placed on the bypass tray with an icon.
Remaining paper Display
Approx. more than 10 mm
(0.40")
*
1 sheet - approx. less than
10 mm (0.40")
*
No paper
To Next Page
Loading...
Need help?
General
