3 BASIC COPY MODES
80 Selecting Finishing Mode
Manual staple mode
You can staple copied paper manually without any copying operation. This is useful when you have forgotten
to set the staple sort mode before starting copying, or when you want to staple originals. (Available only with
the Finisher MJ-1107 or Saddle Stitch Finisher MJ-1108)
Maximum number of sheets available for manual stapling
Use the buttons on the stapling control section of the Finisher (optional) for manual stapling.
1
Press the stapling button on the stapling control section.
The shutter of the paper exit area is opened and this equipment enters into the manual staple mode.
2
Press the stapling position switching button to switch the staple position (front or
rear).
Paper size
Paper weight
64 - 80 g/m
2
(17 - 20 lb. Bond)
81 - 90 g/m
2
(21 - 24 lb.
Bond)
91 - 105 g/m
2
(25 - 28 lb.
Bond)
A4, B5, LT 50 sheets 50 sheets 30 sheets
A3, A4-R, B4, FOLIO,
LD, LG, LT-R, COMP
30 sheets 30 sheets 15 sheets
3
Place paper on the lower receiving tray of the Finisher
(optional).
Fan and jog the paper well. Place it with its face down.
When you staple them at their corner on the front side, place
the sheets of paper aligned to the front side. When you staple
them on the rear side, place the sheets of paper aligned to the
rear side.
The stapling lamp lights when the paper is properly placed. If
it does not light, replace the paper.
Stapling position
button / lamps
Stapling
button / lamp
To Next Page
Loading...
Need help?
General
