3 BASIC COPY MODES
78 Selecting Finishing Mode
5
Select the desired mode from [MAGAZINE SORT], [MAGAZINE SORT & CENTER
FOLD], [MAGAZINE SORT & SADDLE STITCH], [CENTER FOLD] or [SADDLE STITCH].
Then press [OK].
[MAGAZINE SORT & SADDLE STITCH] and [SADDLE STITCH] are selectable only when the
Saddle Stitch Finisher MJ-1108/MJ-1033 (optional) is installed.
[MAGAZINE SORT & CENTER FOLD] and [CENTER FOLD] are selectable only when the
Saddle Stitch Finisher MJ-1108 (optional) is installed.
6
Select other copy modes as required, and then press the [START] button on the control
panel.
Hole punch mode
You can punch copied paper when the Hole Punch Unit (optional) is installed on the Finisher.
Paper whose size is any of A3, A4, A4-R, B4, B5, B5-R, FOLIO, LD, LG, LT, LT-R, ST-R and COMP, and
whose weight is 64 to 209 g/m
2
(17 lb. Bond to 110 lb. Index) (MJ-6104) and 64 to 128 g/m
2
(17 to 34
lb. Bond) (MJ-6007/MJ-6008) is available.
Special paper such as OHP film or sticker labels is not applicable.
1
Place paper in the drawer(s).
When using bypass copying, be sure to set the paper size.
2
Place the original(s).
7
Combine the copied paper if the center fold mode or
magazine sort & center fold mode is used.
In the center fold mode, paper is folded at the center for every 5
sheets before exiting. If more than 5 sheets of paper are copied,
combine them as shown in the figure.
To Next Page
Need help?
General
