1.BEFORE USING EQUIPMENT
Placing Paper 13
1 BEFORE USING EQUIPMENT
Placing paper in drawers
Follow the procedure below to place paper in a drawer. For acceptable copy paper, see the following page:
P.11 “Acceptable copy paper”
1
Turn the power of this equipment ON.
2
Pull out a drawer carefully until it comes to a stop.
3
Place paper in the drawer.
Up to 600 sheets (64 g/m
2
) (17 lb. Bond) can be placed in
one drawer. Be sure that the height of the stacked paper
does not exceed the line indicated inside of the side
guides.
P.11 “Acceptable copy paper”
Fan and jog the stack of paper well before you place it in
a drawer, or the sheets may not be separated before
being fed. Be careful not to cut your fingers when
fanning.
Place paper with its copy side up. The copy side may be
noted on its wrapping paper.
4
Move the end guide to the trailing edge of the paper
while pushing its lower part in the direction of the
arrows.
5
While holding the green lever of the front side guide,
adjust the side guides to the paper size.
Adjust the side guides with both hands.
To Next Page
Loading...
Need help?
General
