1 PREPARATION
10 Components
Components
Front/Left side/Inner side
1. Reversing Automatic Document Feeder (RADF) (optional)
The stack of originals is scanned one sheet at a time. Both sides of the originals can be scanned. A maximum of 50
sheets (80 g/m
2
or 20 lb. Bond) can be placed in one go. (The maximum number of sheets that can be set may vary
depending on the media type of the originals.)
P.139 “Paper Misfeed”
2. Platen sheet
P.154 “Regular Cleaning”
3. Original glass
Place the book-type originals and special paper such as overhead transparencies or tracing paper, as well as plain
paper.
4. Control panel
Make settings to use the various functions on this equipment.
P.14 “Control panel”
5. Toner cartridge
For the recommended toner cartridges, refer to the Safety Information.
P.148 “Replacing Toner Cartridge”
6. Front cover
Open this when you replace the toner cartridge.
P.148 “Replacing Toner Cartridge”
7. Drawer
Place up to 250 sheets of plain paper (80 g/m
2
or 20 lb. Bond).
P.22 “Loading paper in the drawer/Paper Feed Unit”
8. Paper Feed Unit (optional)
Use the Paper Feed Unit to add the second drawer. A maximum of 250 sheets (80 g/m
2
or 20 lb. Bond) of plain paper
can be placed in one go.
9. Paper Feed Pedestal (optional)
Use the Paper Feed Pedestal to add one drawer. The Drawer Module can be installed in this device. A maximum of
550 sheets (80 g/m2 or 20 lb. Bond) can be placed in one go.
To Next Page
Loading...
Need help?
General
