111600XPi Series UPS Installation and Operation Manual – 60616-014
6 Operating Precautions
1. The UPS should not be powered up until the entire operation manual has been read.
2. The voltage of the input power source must be within the range of +10% to -30% of the rated input voltage. The input
frequency must be within the rated input frequency range. Voltages and frequencies outside of the permissible range
may activate the internal protection devices.
3. The UPS should not be used with a load that has a rated input that is greater than the rated output of the UPS.
4. DO NOT use the UPS to provide power to motors that require high starting current or with motors that require a long
starting time, such as vacuum cleaners and machine tools (oversizing the UPS for lock rotor current would be re-
quired).
5. DO NOT insert metal objects or combustible materials in the ventilation slots of the UPS.
6. DO NOT place, hang, or paste any objects on the exterior surfaces of the UPS.
7. The capacitors of the UPS maintain a residual charge for a while after turning the UPS o.
8. DO NOT attempt to disassemble, modify, or repair the UPS. Repairs and servicing should only be performed by
Toshiba Field Service personnel.
9. DO NOT remove any covers of the UPS when the power is on.
10. Turn the power on only after installing ALL of the covers.
11. If the UPS should emit smoke, produce an unusual odor, or make sound, turn the power o immediately.
12. Changing/replacing the UPS Batteries should only be performed by Toshiba eld service personnel.
13. Warning signs should be placed on or near the load as a notication that the load is being powered by the UPS.
14. Additional warnings and notications shall be posted at the equipment installation location as deemed required by
Qualied Personnel.
To Next Page
Loading...
Need help?
General