5-7
■ Display indication list
To be set by the user
Fine adjustment of each of traveling and material handling power
control levels
Traveling speed level Setting of 2-speed travel speed level
Power control select
Adjustment of indicated time
Traveling speed setting for overspeed alarm
GENERAL screen
Press button (3) for 2 sec. or more
Enter password
MASK FUNCTION screen
Speed alarm
Clock set
Power select
To be selected by the user
2-speed travel speed ON/OFF ON or OFF setting of 2-speed travel speed
Switching to hour meter display
Power mode selection
Checking traveling or material handling system operation time
WHEEL DIA WHEEL DIA
FISHERMAN
To be set by dealer or serviceman
ANALYZER
TUNING
OPTION SET
MATCHING
DIAG MEMORY
I/O MONITOR1
I/O MONITOR2
I/O MONITOR3
I/O MONITOR4
ACTIVE TEST
TUNING1
DEMO MODE
H/M START
P/C LOCK
DESTI
B LEVEL
MPH
BATTERY
PARKING ERR
TILT CONT
KNOB CONT
TILT F-LIM
B-TYPE
TILTL
TILTF
LOAD
TIRE
Checking past diagnosis error codes stored in memory
Matching of the tire angle sensor forward direction
Setting the tire constant
Matching of the NL load
LIFT Matching of the lift lever neutral position
TILT Matching of the tilt lever neutral position
ATT1 Matching of the ATT1 lever neutral position
ATT2 Matching of the ATT2 lever neutral position
Matching of the tilt forward restricted angle
Matching of the tilt/level angle
Setting the battery type
Setting the specification of 2-way mini lever models
Setting the specification of 4-way mini lever models
Setting the wheel indicator indication
36V
2-WAY VALVE
4-WAY VALVE
USA
WHEEL IND
SAS Setting the SAS function
Setting the mast forward tilt/level function
Setting the mast forward tilt angle restriction
Setting the parking brake OFF warning
SEAT P-OFF
Setting the operation of the Auto-OFF function in relation to the seat switch
Setting the calculation constant for battery charge indicator
Setting the traveling speed display
C/CNT RES
SHOU-TOKU
Changing display for each destination
Power control lock selection
Starting the hour meter count
Enabling simultaneous traveling and material handling before H/M start
Standard function adjustment
TUNING2 LIFTV Lift lever adjustment
TUNING3 TILTV Tilt lever adjustment
TUNING4 ATT1V ATT 1 lever adjustment
TUNING5 ATT2V ATT 2 lever adjustment
Forced ON/OFF test of each switch
Checking steering knob synchronizer and other sensors
Checking material handling and mast control sensors
Checking traveling-related sensors
Checking the temperature and voltage of each functional part
To Next Page
Loading...
Need help?
General
