5-26
Analyzer menu screen list
*Values shown in the 2nd column are display examples and not the standard values.
ANALYZER MENU
screen
Display
Meaning
1st column 2nd column
1DIAG MEMORY
DIAG-1 to
DIAG-10
Error code and
detection time
Error display
2
I/O MONITOR1
(Voltage/
temperature)
I/O 1-1 THCD: +25/+25
Main drive circuit 1 temperature (heat sink): °C
Main drive circuit 2 temperature (heat sink): °C
I/O 1-2 THCP: +25 Main pump circuit temperature (heat sink): °C
I/O 1-3 TD: +25/+25
Drive motor 1 temperature: °C
Drive motor 2 temperature: °C
I/O 1-4 TP: +25 Pump motor temperature: °C
I/O 1-5 TBD: +25/+25
Traveling AC driver 1 board temperature: °C
Traveling AC driver 2 board temperature: °C
I/O 1-6 TBP: +25
material handling AC driver board tempera-
ture: °C
I/O 1-7 TEMP: +25.0 CPU board temperature: °C
I/O 1-8 VB48: 50.0 Battery voltage: V
I/O 1-9 VBKS: 50.0 Key start voltage: V
I/O 1-10 VBSOL: 50 Solenoid voltage: V
I/O 1-11 VBMB: 50 Voltage after MB contactor: V
I/O 1-12 VBBD: 50/50
Traveling AC driver 1 DC_BUS voltage: V
Traveling AC driver 2 DC_BUS voltage: V
I/O 1-13 VBBP: 50
Material handling AC driver DC_BUS voltage:
V
3
I/O MONITOR2
(Traveling
system)
I/O 2-1
POTA: 0.71
SWAC: 0
Accelerator potentiometer voltage: V
Acceleration switch: 0 (OFF), 1 (ON)
I/O 2-2
DSF: 0
DSR: 0
Forward switch: 0 (OFF), 1 (ON)
Reverse switch: 0 (OFF), 1 (ON)
I/O 2-3
LSB: 1
LSD: 1
Brake switch: 0 (OFF), 1 (ON)
Seat switch: 0 (OFF), 1 (ON)
I/O 2-4
SSD1: 3000
[3000]
Drove motor 1 rpm: rpm
[Main controller instruction rpm: rpm]
I/O 2-5
SSD2: 3000
[3000]
Drove motor 2 rpm: rpm
[Main controller instruction rpm: rpm]
I/O 2-6 SPD: 10.0 Main traveling speed: mph or km/h
To Next Page
Loading...
Need help?
General
