Operator Interface Controls
92 RTHD-SVX02H-EN
Logging In
There are two levels of security:
• Security Level 1 allows users to change a limited
group of secure settings. The default security PIN is
1111.
• Security Level 2 allows users to change all secure
settings. The default security PIN is 7123.
A technician must use the Tracer TU service tool to define
a different PIN, or to recall a PIN that has been forgotten.
When defining a PIN in Tracer TU, the technician enters
a 4-digit PIN that corresponds with the desired level of
security.
To log in:
1. Touch the Log in button. The Log in screen appears
(Figure 63).
2. Use the keypad to enter your PIN.
• The PIN is a four-digit number, which was configured
for your system with the Tracer TU service tool.
• As you enter the number, the PIN remains hidden by
asterisks.
Note: If you enter an invalid PIN, an error message ap-
pears on the Log in screen.
3. Touch Save.
• If you viewed the Log in screen from touching Log in
on the Settings screen, the Settings screen appears
with a Log out button on it.
• If the Log in screen appeared when you tried to
change a setting, you return to that setting screen.
Note: The PIN is valid until 30 minutes of inactivity
passes, or until you log out.
Figure 64. Log In Screen
Logging Out
To log out:
1. Touch the Log out button. A confirmation screen ap-
pears (Figure 65).
2. Touch Yesto confirm that you want to log out. The Set-
tings screen appears with a Log in button on it.
Figure 65. Log out conrmation screen
To Next Page
Loading...
Need help?
General
