RTHD-SVX02H-EN 93
TracerTU
TracerTU (non-Trane personnel, contact your localTrane
office for software) adds a level of sophistication that
improves service technician effectiveness and minimizes
chiller downtime.TheTracer AdaptiView control’s opera-
tor interface is intended to serve only typical daily tasks.
The portable PC-based service-tool software,Tracer TU,
supports service and maintenance tasks. TracerTU serves
as a common interface to allTrane® chillers,andwill
customize itself basedonthe properties of the chiller with
which it is communicating.Thus, the service technician
learns only one service interface. The panel bus is easy
to troubleshoot using LED sensor verification. Only the
defective device is replaced.Tracer TU can communicate
with individual devices or groups of devices. All chiller
status, machine configuration settings, customizable lim-
its, and up to 100 active or historic diagnostics are dis-
played through the service-tool software interface. LEDs
and their respectiveTracerTU indicators visually confirm
the availability of each connected sensor, relay, and actu-
ator. TracerTU is designed to run on a customer’s laptop,
connected to theTracer AdaptiView control panel with
a USB cable.Your laptop must meet the following hard-
ware and software requirements:
• 1 GB RAM (minimum)
• 1024 x 768 screen resolution
• CD-ROM drive
• Ethernet 10/100 LAN card
• An available USB 2.0 port
• Microsoft
®
Windows
®
XP Professional operation sys-
tem with Service Pack 3 (SP3) or Windows 7 Enter-
prise or Professional operating system (32-bit or 64-
bit4.0 or later.
Note: TracerTU is designed and validated for this mini-
mum laptop configuration.Any variation from this
configuration may have different results. There-
fore, support forTracerTU is limited to only those
laptops with the configuration previously speci-
fied.
Figure 66.
To Next Page
Loading...
Need help?
General
