Operator Interface Controls
RTHD-SVX02H-EN 87
Figure 50. Report Compressor Screen
Table 27. Report Compressor Screen Items
Description Resolution Units
Compressor Running Status On,Off Text
Average Motor Current %RLA XX.X% %RLA
Compressor Starts XX Text
Compressor Running Time XX:XX Hr:Min
Oil Loss Level Sensor Wet, Dry Text
Discharge Temperature X.X
°
F /
°
C
Discharge Temperature X.X
°
F /
°
C
Compressor Oil Pressure XXX.X PSIA/kPaA
Evaporator Refrigerant Pressure XXX.X PSIA/kPaA
Condenser Refrigerant Pressure XXX.X PSIA/kPaA
Differential Refrigerant Pressure XXX.X PSIA/kPaA
Figure 51. Report Motor Screen
Table 28. Report Motor Screen Items
Description Resolution Units
Active Current Limit Setpoint X.X %RLA
Average Motor Current %RLA X.X %RLA
Starter Motor Current L1 %RLA X.X %RLA
Starter Motor Current L2 %RLA X.X %RLA
Starter Motor Current L3 %RLA X.X %RLA
Starter Motor Current L1 X.X A
Starter Motor Current L1 X.X A
Starter Motor Current L1 X.X A
Starter Input Voltage AB XXX.X V
Starter Input Voltage BC XXX.X V
Starter Input Voltage CA XXX.X V
Average Motor Current X.X A
Average Phase Voltage XXX.X V
Equipment Settings
You can use the TD7 display to monitor and change a
variety of equipment settings.
Viewing the Settings Screen
Touch the Settings button in the main menu area (see
Figure 43) to view the Settings screen. Equipment Set-
tings identifies a column of buttons located on the
screen (see the outlined column in Figure 52). The but-
tons are:
• Chiller Settings
• Feature Settings
• Chiller Water Reset
• Manual Control Settings
Each of these buttons provide access to a screen that
contains additional buttons related to eachtopic. This sec-
tion provides detailed information about these screens.
Figure 52. Setting Screen
Viewing and Changing Equipment Set-
tings
Each button in the Equipment Settings column on the
Settings screen takes you to a menu screen that contains
a group of buttons. Each button displays the name of a
setting and its current value(Figure 53). Touch any button
to view a screen where you can change the setting for
the featureshown on the button.
Note: A page number appears in the lower right corner
of the screen. If a screen contains more than one
page, up/down arrows also appear for viewing
the other pages, as in Figure 53