General Information
26
Traction Control (TC) Disabled
Warning Light
The TC disabled warning light
should not illuminate unless
traction control is switched off
or there is a malfunction,
If the warning light becomes illuminated
at any other time while riding, it
indicates that the traction control has a
malfunction that requires investigation.
Direction Indicators
When the direction indicator
switch is pushed to the left or
right, the direction indicator
light will flash on and off at the same
speed as the direction indicators.
High Beam
When the ignition is switched
on and the high beam button
is pressed, the high beam
warning light will illuminate.
Daytime Running Lights (if fitted)
When the ignition is switched
ON and the daytime running
lights switch is set to ’daytime
running lights’, the daytime running
lights warning light will illuminate.
Low Fuel
The low fuel indicator will
illuminate when there are
approximately 3.5 litres of fuel
remaining in the tank.
Neutral
The neutral warning light
indicates when the
transmission is in neutral (no
gear selected). The warning
light will illuminate when the
transmission is in neutral with the
ignition switch in the ON position.
If the traction control is not
functioning, care must be taken when
accelerating and cornering on
wet/slippery road surfaces to avoid
rear wheel spin. Do not continue to
ride for longer than is necessary with
the Engine Management System
Malfunction Indicator Light
(MIL) and
traction control warning lights
illuminated. Contact an authorised
Triumph dealer as soon as possible to
have the fault checked.
Hard acceleration and cornering in
this situation may cause the rear
wheel to spin resulting in loss of
motorcycle control and an accident.
To Next Page
Loading...
Need help?
General
