General Information
33
To access the SIA display, with the
motorcycle stationary and in neutral,
turn the ignition to the ON position.
Press and release button 'A' until SEtUP
is shown in the display screen then
press button 'B'.
Press and release button 'A' until SIA is
shown.
To exit the SIA display, press and release
button ’A’ until REtURn is shown in the
display screen, then press button B.
Gear Change Lights
The gear change lights provide a visual
indication of when to change gear. The
gear change lights are all coloured blue.
1. Gear change lights
2. Display screen
3. Button A
4. Button B
Gear Change Light Modes
The gear change lights have four
programmable operating modes as
described below:
• 3 LED mode: The first three lights
illuminate when the set limit is
reached, and remain illuminated until
the engine speed drops below the
set limit.
• 6 LED mode: All six lights illuminate
when the set limit is reached, and
remain illuminated until the engine
speed drops below the set limit.
• SE mode: The lights will progressively
illuminate in 250 rpm increments
until the set limit is reached. At the
set limit all six lights will be
illuminated.
• OFF mode: The gear change lights
are turned OFF.
To Next Page
Loading...
Need help?
General
