General Information
42
The flashing of two riding mode icons
together indicates that MAP, ABS or TTC
settings specified by the selected riding
mode have not been correctly selected.
In this case the MIL, ABS or TTC warning
light(s) may be illuminated depending on
the current state of each system.
In the event of an incomplete riding
mode change:
• Safely bring the motorcycle to a stop
• Select neutral gear
• Turn the ignition OFF and then back
ON again
• Select the desired riding mode
• Restart the engine and continue
riding.
Note:
• If the mode icons are not shown
when the ignition switch is in the ON
position, ensure the engine stop
switch is in the RUN position.
Do not stop the engine using the
ignition switch or engine stop switch
whilst the motorcycle is moving.
Always bring the motorcycle to a stop
safely and engage neutral gear prior
to stopping the engine.
Stopping the engine by turning off the
ignition or engine stop switch whilst
the motorcycle is moving can lock the
rear wheel causing loss of motorcycle
control and an accident.
The engine should not be stopped by
turning the ignition switch to the
OFF position when the motorcycle is
moving. The engine stop switch is for
emergency use only.
Stopping the engine when the
motorcycle is moving may cause
damage to motorcycle components
leading to loss of motorcycle control
and an accident.
To Next Page
Loading...
Need help?
General
