27
General Information
Switch Operation
This is a three position, key operated switch.
The key can be removed from the switch
only when it is in the OFF or P (PARK)
positions.
To turn the switch from OFF to ON, insert
the key and turn the key clockwise to the ON
position.
To turn the switch from ON to PARK, push
the key barrel further into the lock and turn
clockwise to the PARK position. Use the PARK
position only when temporarily leaving the
motorcycle in a situation where the position
lights must remain on.
To turn the key back to OFF, turn the key
anti-clockwise.
Ignition Switch Positions
Note:
• Do not leave the ignition switch in
the P position for long periods as
this will cause the battery to
discharge.
Engine off. All electrical circuits
off.
Engine on. All electrical
equipment can be used.
Engine off. Tail, side and licence
plate lights on, all other electrical
circuits cut off.
For reasons of security and safety, always
turn the ignition to the OFF or PARK
position and remove the key when leaving
the motorcycle unattended.
Any unauthorised use of the motorcycle
may cause injury to the user, other road
users and pedestrians and may also cause
damage to the motorcycle.
Additional keys or key rings attached to the
ignition key may cause damage to the
motorcycle’s painted or polished
components. Remove any such item from
the ignition key to prevent damage to
painted or polished components when the
motorcycle is ridden.
To Next Page
Loading...
Need help?
General
