TSI Instruments SMPS 3938 User Manual

5-18 Electrostatic Classifier Model 3082 and SMPS Spectrometer Model 3938
Using t h e Setup Sc r e e n
Use the Setup screen to view details about peripheral instrumentation,
change scan and scheduling parameters, change reference gas
parameters, set the date and time, calibrate the touch-screen display,
specify communication options, see information about the instrument, view
diagnostic information, calibrate impactor and sheath flow rates, zero
differential pressure sensor, restore factory default settings, set up logging
options, and export data. Figure 5-7 below shows the Classifier mode
Setup screen.
Figure 5-7
Electrostatic Classifier Setup Screen
The Setup screen options are listed in Table 5-5 and described on the
following pages.
Table 5-5
Electrostatic Classifier Setup Screen Options
Option
Description
Properties
Edit the SMPS spectrometer hardware configuration, scan
and scheduling parameters, and reference gas parameters.
Device
Set the date and time, calibrate the touch-screen display,
specify communication options, see information about the
instrument, and view diagnostic information.
Calibration
Calibrate the impactor and sheath flow rates, zero the
differential pressure sensor, and restore factory default
settings.
Data Export
Export or delete internally logged data.
Logging Options
Set up logging options such as whether raw data is saved,
where data is saved (to USB flash drive or to internal SD card),
and delimiter options.

TSI Instruments SMPS 3938 Specifications

General

Brand	TSI Instruments
Model	SMPS 3938
Category	Laboratory Equipment
Language	English