Instrument Operation 5-3
Same as SMPS mode, but with more options for
data analysis. Aerosol Instrument Manager
software on a personal computer controls the DMA
and detector during an SMPS spectrometer scan,
shows the scan data in a graphical format, and
performs data collection and analysis. For a
complete description of how to use Aerosol
Instrument Manager software, refer to Aerosol
Instrument Manager
®
Software for SMPS™
Spectrometer Instruction Manual (part number
1930038).
Note: When operating the classifier using remote
control, buttons on the main screen are
disabled.
C a u t i o n
If you intend to use remote operation for the SMPS spectrometer, verify
that the system is not reporting errors before you leave the instrument
unattended. Watch the SMPS spectrometer until the first scan has
completed in order to check for expected results.
Title Bar
The title bar at the top of the display screen indicates the status of the
instrument and provides error messages to help you troubleshoot any
problems. The title bar is displayed in blue, yellow, or red, depending on
error state:
Indicates the instrument is operating as expected.
Indicates a warning condition. When the title bar is yellow, the
wrench icon appears. Touch the wrench to see a description of
the warning condition.
Indicates an error condition. When the title bar is red, the wrench
icon flashes. Touch the wrench to see a description of the error
condition.
To Next Page
Loading...
Need help?
General
