6-1
C H A P T E R 6
M a i n t e n a n c e , S e r v i c e ,
a n d Tr o u b l e s h o o t i n g
This chapter describes recommended maintenance procedures for the
Electrostatic Classifier and is intended to be used by a trained service
technician.
The frequency of routine maintenance procedures depends upon the
frequency of use of the instrument and the operating conditions. A
suggested maintenance schedule is listed in Table 6-2.
If you contact TSI for assistance, please have the classifier close to the
telephone when discussing the problem with a TSI technician.
W A R N I N G
Service and Maintenance procedures described in this section should
only be performed by a qualified, trained service technician.
You can purchase a 3082R-MAINT Model 3082 Maintenance Kit to
perform routine maintenance procedures on your classifier. Table 6-1 lists
the components contained in the maintenance kit.
Table 6-1
3082R-MAINT Model 3082 Electrostatic Classifier Maintenance Kit
Part Number/
Model Number
Filter media for fan guard
DMA Dacron Screen Assembly
1-025 O-rings (3082 inlet internal radial seal)
1-207 conductive O-rings (inlet/impactor face seal)
1-017 O-rings (impaction plate external radial seal)
1-014 O-rings (DMA center rod)
1-010 O-rings (used in DMA and 3082 maintenance)
To Next Page
Loading...
Need help?
General
