Unpacking and Setting Up 2-13
Installing the Model 3088 Neutralizer
W A R N I N G
The Model 3088 Advanced Aerosol Neutralizer contains an x-ray
source, which may be subject to local regulations. During normal
operation, you will not be exposed to x-ray radiation. Do not detach the
x-ray source from the neutralizer tube.
C a u t i o n
When installed, the neutralizer completes a flow path inside the
classifier. If you operate the classifier with an external neutralizer or
without any neutralizer, the provided impactors cannot be used, and
aerosol flow rate cannot be measured by the classifier.
To install the Model 3088 Advanced Aerosol Neutralizer, follow these
instructions:
1. If the flag assembly has already been removed, continue with step 3. If
the flag assembly has not been removed, using a Phillips-head
screwdriver, remove the two screws securing the flag assembly and
save for reuse.
2. Lift out the flag assembly by placing your fingers in the depressions on
either side and pulling up on the Polydisperse Flow outlet port. Save
the flag assembly for reuse.
3. Remove the black vinyl end caps from the Model 3088 Neutralizer.
To Next Page
Loading...
Need help?
General
