Ubee Interactive Connecting Devices to the Network
Ubee UBC1301-AA00 Advanced Wireless Voice Gateway Subscriber User Guide • March 2017 14
The screws should protrude from the wall so that you can fit the device between the
head of the screw and the wall. If you install the screws in drywall, use hollow wall
anchors to ensure the unit does not pull away from the wall due to prolonged strain
from the cable and power connectors.
2. Mount the device on the wall.
2.2 Connecting Devices to the Network
Use the instructions below to connect network devices and validate device functionality.
See the following topics:
Connecting an Ethernet Device on page 14
Connecting a Telephone Line on page 15
Connecting a Wireless Device on page 15
2.2.1 Connecting an Ethernet Device
You can connect up to three additional Ethernet devices to the UBC1301-AA00.
To connect another Ethernet device to the network:
1. Connect an Ethernet cable from the Ethernet device (for example, a PC or gaming
console) to an open Ethernet port on the back of the UBC1301-AA00.
2. Use the device LEDs to confirm operations. Refer to LED Behavior on page 6 for more
information.
3. Open a Web browser and go to any Web site to validate network/Internet connectivity
(for example, http://www.wikipedia.org).
4. If the connected device is a gaming console, perform any online task supported by the
console (for example, log into the gaming server, play an online game, download
content).
Refer to Troubleshooting the Installation on page 16 for troubleshooting information.
To Next Page
Loading...
Need help?
General
