Ubee UBC1301-AA00 User Manual

Ubee Interactive Using the LAN Option
Ubee UBC1301-AA00 Advanced Wireless Voice Gateway Subscriber User Guide • March 2017 37
6.2 Using the LAN Option
Use the LAN option to view information regarding the LAN interfaces of the UBC1301-
AA00.
To view LAN interface information:
1. Click Gateway from the main menu.
2. Click LAN on the left side menu.
3. The following sub-menus are available for selection:
 Using the DHCPv4 Option on page 37
 Using the DHCPv6 Option on page 39
 Using the DHCP Lease Option on page 41
6.2.1 Using the DHCPv4 Option
The DHCPv4 screen allows you configure IPv4 DHCP (dynamic host configuration
protocol) behavior.
To configure DHCPv4 settings:
1. Click LAN from the left side menu.
2. Click DHCPv4 under LAN.
Field descriptions are listed below the screen example.
Label Description
Bridge
mode
Operates the device as a Bridge device when enabled. Bridge Mode can only be enabled when logged is
an admin (vs. end user). Bridge Mode affects the entire device, meaning all networks become bridged.
Only the Status and Wireless menus are visible when in Bridge mode.
Note: If you place a device in Bridge mode, and only one public IP address has been provisioned for the
customer premises equipment (CPE), i.e, a Home Router, consider disabling the Wireless SSID to avoid
a wireless client inadvertently acquiring the single Public IP address assigned via DHCP.
NAT
mode
Operates the device in network address translation (NAT) mode when enabled. NAT mode is selected by
default and enables all gateway features of the UBC1303-AA00. NAT mode is the default operation mode
when the device is reset to factory defaults.
NAT mode provides a wireless access point that allows sharing a single Internet connection. Enables
Layer 3 IP protocol, DHCP for private IP address assignment, NAT for network address and port
translation, IP routing, firewall protection, and parental control features. Hint: All LAN and wireless LAN
interfaces are on the same Private IP subnet, and are translated to a single Public IP address on the
WAN gateway interface to the Internet.
Apply Applies the selected operation mode.

Ubee UBC1301-AA00 Specifications

General

Brand	Ubee
Model	UBC1301-AA00
Category	Gateway
Language	English