SHENZHEN CENTER POWER TECH CO., LTD
Address: Rooms 9-12, 7F, Block B, Building 7, Zone 2, Shenzhen Bay Technological and
Ecological Park, Nanshan District, Shenzhen, China
Tel: 0755-66851118 Fax: 0755-66850678 Email: sales@vision-batt.com
Green Our Earth Power Your Vision
3.3.4 Personnel requirement
Operators should be fully familiar with the system composition and working
principles of entire REVO series products.
The operator should be fully familiar with the Manual of the product.
3.3.5 Battery protection
There is a deadly high voltage in the energy storage backup battery between
the positive and negative poles of the battery system!
During installation or maintenance, make sure that the connection between
the battery pack and the UPS is completely disconnected.
3.3.6 Electric measurement
After the installation of the energy storage backup battery, there is a high
voltage. An accidental contact with the positive and negative poles may lead
to deadly injury. Therefore, please watch out when you need to measure the
power.
Prepare for insulation protection (e.g. wearing insulating gloves, etc.)
To ensure personal safety, one must be accompanied by others.
3.3.7 Expert Users Measuring Instrument
To ensure that the electrical parameters meet the requirements, relevant electrical
measuring equipment should be used during the electrical connection and trial operation of
the REVO system.
The measuring equipment with appropriate measuring range should be in line
with the on-site working conditions.
Ensure correct and standard electrical connection of the instrument.
Avoid the arc danger.
To Next Page
Loading...
Need help?
General
