Vision REVO User Manual

SHENZHEN CENTER POWER TECH CO., LTD
Address: Rooms 9-12, 7F, Block B, Building 7, Zone 2, Shenzhen Bay Technological and
Ecological Park, Nanshan District, Shenzhen, China
Tel: 0755-66851118 Fax: 0755-66850678 Email: sales@vision-batt.com
Green Our Earth Power Your Vision
84
The AC input of CBMS from AC power source should be connected with
a miniature circuit breaker to ensure safety. The recommended
parameters of this circuit breaker are as follows
Pole number
2
Rated Voltage
400VAC
Rated current
16A
Figure 10.6-29 CBMS parallels AC power connection
Note that the unconnected interface on the left end needs to be connected
with a terminal cap
10.6.8 Set the dial switch
In order to ensure the overall stability of the system, the parallel communication of lithium
battery system adopts CANBUS mode. In order to distinguish the address access of its
equipment for communication during the parallel state, it is necessary to set reasonable
addresses of different equipment through the dial code switch on the CBMS panel to

Vision REVO Specifications

General

Brand	Vision
Model	REVO
Category	3D Glasses
Language	English