Check the warning lamps and LEDs
Each time the ignition is turned on, all bulbs and
LEDs are illuminated on the main control panel.
Check that all bulbs and LEDs function.
If the boat has more than one control panel, the
lamps on the other panel(s) are not checked until the
control panel(s) is(are) activated.
Activate the control position and lock the
system.
Press the activation button for at least one second.
When the button is released, the indication lights up
to confi rm that the control position is activated.
NOTE! If the indicator fl ashes, the control position
has not been activated because the control lever(s)
are not in the neutral position or the system has been
locked from another control panel.
If the boat has more than one control panel, the sys-
tem can be locked, so that the engine can only be
controlled from the activated control board. Press the
activation button for a further second to lock the sys-
tem. The padlock sign lights up in confi rmation.
Unlock the system by pressing the activation button
for one second. This can only be done from an acti-
vated control panel.
Running
Preparations
1. Put the control lever(s) to neutral at all control po-
sitions.
Two lever control: Also check that the engine
speed lever is in the idling position.
2. Turn the starter key to position I to switch the igni-
tion on.
47
Operation
To Next Page
Loading...
Need help?
General
