smartPRINTER Operating Instructions
smartPRINTER Operating Instructions 003/10.2017 41
7.3.5 Network Installation with Use of DHCP Server
Connect the smartPRINTER to your server or router with the LAN cable and to the mains power
using the power cable.
Automatic address assignment on the network via DHCP is switched on (active) in the printer default
settings.
Switch the smartPRINTER on. Press the ON/OFF button to switch the printer on.
You can query the addresses assigned to the printer in the [Printer Settings] menu.
Note:
You can change the language via menu items on the display.
The default menu language is English.
Hold the right-hand button of the directional pad down until the graphics for the menu appear on the
display.
Changing the menu language
Select [Printer Setting] and press the Enter button. Select the [LCD Language] menu item and
confirm by pressing the Enter button. Select German as your desired menu language. Confirm the
selection by pressing the Enter button.
Querying the Addresses
Select the [Accessories] menu item with the directional pad and confirm the selection by pressing
the Enter button.
Select the sub-menu item [Network Settings] and confirm the selection by pressing the Enter button.
[Port Number] 09100 must be entered here. Press the right-hand button on the directional pad and
navigate to [DHCP].
To Next Page
Loading...
Need help?
General
