Xerox 3635MFP - Phaser B/W Laser User Manual

Unix
Xerox Phaser 3635 System Administration Guide 23
Unix
HP-UX Client (Version 10.x)
HP-UX workstations require specific installation steps to communicate with the machine.
The machine is a BSD-style UNIX printer, whereas HP-UX is a System V-style UNIX.
IMPORTANT: All UNIX commands are case sensitive, so enter the commands exactly as
they are written.
Information Checklist
Before starting the installation procedure, please ensure that the following items are
available and/or the tasks have been performed:
1. Existing operational network utilising the TCP/IP protocol.
2. Ensure that the machine is connected to the network.
3. Static IP Address for the machine.
4. Subnet Mask Address for the machine.
5. Gateway Address for the machine.
6. Host Name for the machine.
Procedure
1. Follow the steps in Chapter 3, Configure Static IPv4 Addressing using the Machine
User Interface, Procedure on page 14 until step 38, then return to this page.
Configure the Client
1. Add the machine Host Name to the etc/hosts file on the HP-UX workstation.
2. Ensure that you can ping the machine from the HP-UX workstation.
3. Use either the GUI method or the tty methods as detailed below:
GUI Method
1. Open a [Command] window from the Desktop.
2. Enter su to access Super User mode.
3. Enter sam to start the System Administrator Manager (SAM).
4. Click on the [Printers and Plotters] icon.
5. Click on [lp] spooler.
6. Click on [Printers and Plotters].
7. Click on [Actions: Add Remote Printer/Plotter...].
8. Enter the following information into the [Add Remote Printer/Plotter] form:

Xerox 3635MFP - Phaser B/W Laser Specifications

General

Brand	Xerox
Model	3635MFP - Phaser B/W Laser
Category	All in One Printer
Language	English