Xerox 8850 System Introduction

XES Synergix 8825/8830/8850/8855 & X2-TECH System Introduction 38
Using Test Prints
PRINTER CONFIGURATION Test Print
The Configuration test print provides key information as to the current
Controller Configuration and Error Log, Print Engine Configuration and Error
Log, Installed Media, Communication Parameters (including port and protocol
enables), Network Interface Card Hardware (HW) addresses, status of Job
Accounting, and Scanner Configuration. When trouble arises, print out a
copy of the PRINTER CONFIGURATION Test Print to review error logs and
to see if all options and enables are correctly set.
The test print shown to the right is a sample from Firmware Release 6.1.
Your Test Print will be similar in appearance, but may be different in the data
displayed based upon your installed hardware, installed feature keys, and
firmware version.
Figure 16. Typical Printer Configuration Test Print

Xerox 8850 Specifications

General

Brand	Xerox
Model	8850
Category	Printer
Language	English