XES Synergix 8825/8830/8850/8855 & X2-TECH System Introduction 42
8825/8830/8850 Printer Control
Panel Displayed Error Codes
Status Code Explanation
C0.-- This code indicates a cutter problem. Follow the instructions on the Message Display.
C1.-- This code indicates a problem with Roll 1. Follow the instructions on the Message Display.
C2.-- This Code indicates a problem with Roll 2. Follow the instructions on the Message Display.
C3.-- This code indicates a problem with Roll 3. Follow the instructions on the Message Display.
C4.-- This code indicates a problem at the cut sheet bypass. Follow the instructions on the Message Display.
E2.-- This code indicates a problem in the paper path. Follow the instructions on the Message Display.
E4.-- This code indicates a problem in the fuser area. (Trail or lead edge jam. Stripper finger sensor jam. Copy exit sensor, activate bypass sensor, or
accordian jam sensor was detected to be actuated when the machine was powered-up.) Follow the instructions on the Message Display.
E5.-- This code indicates an interlock problem. (Developer cover, cutter cover, cut sheet shelf, or front door was opened while machine was in run mode.)
Follow the instructions on the Message Display.
E6.-- This code indicates a problem in the paper path. Follow the instructions on the Message Display.
E7.-- Communication failure with the controller. Switch the printer off. Wait a few seconds, then switch the printer on.
E9.-- Switch the printer off. Wait a few seconds, then switch the printer on.
F1.-- This code indicates a problem in communicating with the folder. Follow the instructions on the Folder Message Display.
J1.01 This code indicates that the toner cartridge is out of toner and should be replaced. Refer to the CARE section, “Replacing the Toner Cartridge,” in the
Xerox 8825/8830 Printer Operator Manual.
J2.02 This code indicates that the toner cartridge is not installed correctly. Refer to the CARE section, “Replacing the Toner Cartridge,” in the Xerox 8825/8830
Printer Operator Manual.
LL.-- Communications, sensor, or fuser errors. Switch the printer off. Wait a few seconds, then switch the printer on.
U1.01 Copy counter disconnected. Call for service.
To Next Page
Loading...
Need help?
General