XES Synergix 8825/8830/8850/8855 & X2-TECH System Introduction 44
8855 Printer Displayed Error
Codes
The 8855 Printer has a small interface consisting of five 7-segment LEDs
(light emitting diodes). The LEDs are used to display printer status, errors, or
other conditions that might require user intervention.
8855 Printer Displayed Error Codes
Status Code Explanation
0 (Blinking) Printer is warming up or is making an internal test print
SLP-0 Printer is in maximum power saving mode
SLP-1 Printer is in reduced power saver mode
01-xx Indicates xx size media is loaded in Roll 1 (top) drawer
02-xx Indicates xx size media is loaded in Roll 2 (middle) drawer
03-xx Indicates xx size media is loaded in Roll 3 (bottom) drawer
04-xx Indicates xx size media is loaded in Roll 4 (bottom) drawer
05-xx Indicates xx size cut sheet is loaded on manual bypass
E-xx Printer requires powering off, then back on
H-01 Toner waste container is not installed properly
J-xx Media jam in printer
L-01 Printer is low on toner
P-0x Roll x is out of media, or is loaded incorrectly
U-01 Top drawer is not closed
U-02 Middle drawer is not closed
U-03 Bottom drawer is not closed
U-04 Inner transport is not closed
To Next Page
Loading...
Need help?
General