132 6 Troubleshooting
SysError ***-***
Reboot printer
A system error occurred.
Switch the power off, wait for the display to go out, and then switch the power back
on. If the same error code is displayed, copy down the error code (***-***), and
Contact your Customer Support Center or your dealer.
Refer to
• "Error Codes" (P. 133)
UnknownPaperType
Press SET
and Cancel JOB
Auto Paper Tray select was requested when [Paper Priority] is set to [Off].
Cancel the print job by pressing the
<OK/Eject> button on the control panel.
Set the priority order of the paper trays or manually select a paper tray on the control
panel.
Refer to
• "[System Settings]" (P. 94)
Wrong paper size
Reload Bypass
The paper size loaded in Tray 1 (Bypass tray) does not match the paper size set on
the print driver or on the control panel.
Load paper of the size set on the print driver or on the control panel.
Refer to
• "Loading Paper in Tray 1 (Bypass Tray)" (P. 62)
Wrong paper size
Reload Tray N
Or check Dial
(N: tray 2 - 5)
The paper size loaded in the tray N does not match the paper size set with the paper
size dial.
Pull out the tray N, check the paper size and the paper size dial, and insert the tray.
Refer to
• "Loading Paper in Trays 2 - 5" (P. 64)
Message Symptom/Cause/Remedy
To Next Page
Loading...
Need help?
General