7.10 Moving the Printer 179
7.10 Moving the Printer
Use the following procedure when moving the printer.
CAUTION
• The machine (only main unit including a consumable) weighs 23.5 kg. Make sure to
carry the equipment using two or more persons.
• When lifting the machine, firmly grip the recessed areas provided on both sides of the
machine. Never try to lift the machine by gripping any other areas. Lifting the machine by
gripping any other areas can cause the machine to fall and result in injuries.
Important
• If the optional sheet feeders are installed, remove them before moving the printer. If they are not
securely installed, they may fall and cause injuries. For information on how to uninstall the sheet feeders,
refer to the installation guide provided with the sheet feeders.
1. Remove the paper from Tray 1 (Bypass tray), and close Tray 1 (Bypass tray) cover.
Re-wrap the paper and store it away from dust and humidity.
Important
• When closing Tray 1 (Bypass tray) cover, be careful not to get your fingers caught between (the left or
right edge of) the cover and the printer.
2. Switch the power off by pressing the power switch located on the front lower right of
the printer to the <O> position.
3. Unplug the power cord, interface cable, and all the other cables from the printer.
4. Pull the front cover release levers ("A") on both sides of the printer towards you and
open the front cover.
5. Open the top cover.
6. Remove the print cartridge from the printer.
Important
• Do not touch the interior of the printer. Some parts may be hot.
• Make sure to remove the print cartridge before moving the printer. Otherwise, the toner may spill in the
printer.
• Do not shake the print cartridge after removing it. The toner may spill.
Note
• For information on how to remove the print cartridge, refer to "Replacing the Print Cartridge" (P. 141).
To Next Page
Loading...
Need help?
General