Regulatory Information
228 Xerox
®
VersaLink
®
B405 Multifunction Printer
User Guide
ENERGY STAR
The ENERGY STAR program is a voluntary scheme to promote the
development and purchase of energy efficient models, which help to
reduce environmental impact. Details on the ENERGY STAR program and
models qualified to ENERGY
STAR can be found at the following website:
www.energystar.gov/index.cfm?fuseaction=find_a_product.showProductGr
oup&pgw_code=IEQ
The ENERGY
STAR and ENERGY STAR mark are registered United States
trademarks.
The ENERGY STAR Imaging Equipment Program is a team effort between
United States, European Union, and Japanese governments and the office
equipment industry to promote energy-efficient copiers, printers, fax,
multifunction printers, personal computers, and monitors. Reducing product
energy consumption helps combat smog, acid rain, and long-term changes
to the climate by decreasing the emissions that result from generating
electricity.
For additional information on energy or other related topics, go to
www.xerox.com/about-xerox/environment/enus.html or
www.xerox.co.uk/about-xerox/environment/engb.html.
Power Consumption and Activation Time
The amount of electricity that a device consumes depends on the way the device is used. This device is
designed and configured to enable you to reduce your electricity usage.
Power Saver modes are enabled on your device to reduce energy consumption. After the last print, the
device transitions to Ready mode. In this mode, the device can print again immediately. If the device is
not used for a specified period, the device transitions to Low Power mode, then to Sleep mode. In these
modes, to enable reduced-power consumption, only essential functions remain active. The device takes
longer to produce the first print after it exits the Power Saver modes than it takes to print in Ready
mode. This delay is the result of the system waking up and is typical of most imaging devices on
the market.
To save power, you can enable Auto Power Off mode on your device. If Auto Power Off mode is enabled,
you can configure the mode as follows:
• Always Allowed: The device powers off automatically after the specified time, and the cumulative
Low Power mode and Sleep mode timeouts have elapsed.
• Allowed ONLY When Conditions are Met: The device automatically powers off only after timeouts
have elapsed. The device also powers off if Fax, USB Drive, and Wired and Non-Wired Network have
not been activated.
To change the Power Saver settings, refer to the User Guide at www.xerox.com/office/VLB405docs . For
further assistance, contact your System Administrator or refer to the System Administrator Guide.
To enable Auto Power Off mode, contact your System Administrator. For details, refer to the System
Administrator Guide at www.xerox.com/office/VLB405docs.
To Next Page
Loading...
Need help?
General
