EasyManuals Logo

Yaesu FT-2000D User Manual

Yaesu FT-2000D
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
Page 76 FT-2000D OPERATING MANUAL
VOICE MEMORY
(
SSB/AM/FM MODES
)
You may utilize the Voice Memory capability of the FT-2000D for repetitive messages. The Voice Memory system in-
cludes four memories capable of storing up to 20 seconds of voice audio each. The maximum that any memory can hold is
20 seconds.
Recording Your Own Voice in Memory
1. Select the LSB, USB, AM, or FM mode using the front
panel
[
MODE
]
buttons.
2. Press the
[
F5
(
MEM
)]
button. A blinking “ ” icon
will appear in the display.
3. Within five seconds of pressing the
[
F5
(
MEM
)]
but-
ton, press any of the buttons numbered
[
F1
(
CH-1
)]
through
[
F4
(
CH-4
)]
to select that memory storage reg-
ister. If you do not press the PTT switch (see next step)
within five seconds, the memory storage process will
be cancelled.
4. Press the microphone’s PTT switch momentarily, the
” icon will glow steadily, and recording will
begin.
5. Speak into the microphone in a normal voice level to
record the message (such as “CQ DX, CQ DX, this is
W 6 Delta X-Ray Charlie, W 6 Delta X-Ray Charlie,
Over”). Remember that the time limit for recording
any message is 20 seconds.
6. Press the
[
F5
(
MEM
)]
button to terminate the message
storage process.
Checking Your Recording
1. Be sure that the front panel
[
MOX
]
and
[
VOX
]
but-
tons are both “Off” (the LED imbedded in the switch
is must be off).
2. Press the
[
F1
(
CH-1
)]
~
[
F4
(
CH-4
)]
button (which-
ever one you just recorded in), and you will hear the
contents of the voice memory you just recorded.
ADVICE:
You may adjust the playback level of the recording via
Menu item “016 dUS RX LVL.”
Transmitting the Recorded Message
1. Select the LSB, USB, AM, or FM mode using the front
panel
[
MODE
]
buttons.
2. Press the front panel’s
[
BK-IN
]
button.
3. Press the
[
F1
(
CH-1
)]
~
[
F4
(
CH-4
)]
button, depend-
ing on which memory registers message you wish to
transmit. If you hit the key again during playback, the
message will be terminated.
ADVICE:
You may adjust the transmit (audio) level of the recording
via Menu item “017 dUS TX LVL.”
[
F1
(
CH-1
)]
~
[
F4
(
CH-4
)]
Button
[
F5
(
MEM
)]
Button
[
BK-IN
]
Button
[
MOX
]
Button
TRANSMITTER CONVENIENCE FEATURES

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yaesu FT-2000D and is the answer not in the manual?

Yaesu FT-2000D Specifications

General IconGeneral
BrandYaesu
ModelFT-2000D
CategoryTransceiver
LanguageEnglish

Related product manuals