Page 77FT-2000D OPERATING MANUAL
VOICE MEMORY
(
SSB/AM/FM MODES
)
TRANSMITTER CONVENIENCE FEATURES
Voice Memory Operation from the optional FH-2 Remote Control Keypad
You may also utilize the Voice Memory capability of the FT-2000D from the optional FH-2 Remote Control Keypad
which plugs into the rear panel’s REM jack.
When using the FH-2 Remote Control Keypad, you may record five memories with up to 20 seconds of voice audio each.
LOCK
OFFON
LOCK
OFFON
LOCK
OFFON
LOCK
OFFON
Recording Your Own Voice in Memory
1. Select the LSB, USB, AM, or FM mode using the front
panel
[
MODE
]
selector buttons.
2. Press the
[
MEM
]
key on the FH-2.
3. Press any of the FH-2’s keys numbered
[
1
]
through
[
5
]
to select that memory storage register. If you do
not press the PTT key (see next step) within five sec-
onds, the memory storage process will be cancelled.
4. Press the microphone’s PTT switch momentarily, the
“ ” icon will glow steadily, and recording will
begin.
5. Speak into the microphone in a normal voice level to
record the message (such as “CQ DX, CQ DX, this is
W 6 Delta X-Ray Charlie, W 6 Delta X-Ray Charlie,
Over”). Remember that the time limit for recording
any message is 20 seconds.
6. Press the FH-2’s
[
MEM
]
key to terminate the message
storage process.
Checking Your Recording
1. Be sure that the front panel
[
MOX
]
and
[
VOX
]
but-
tons are both “Off” (the LED imbedded in the button
must be off).
2. Press the FH-2’s
[
1
]
~
[
5
]
key (whichever one you just
recorded in), and you will hear the contents of the voice
memory you just recorded.
ADVICE:
You may adjust the playback level of the recording via
Menu item “016 dUS RX LVL.”
Transmitting the Recorded Message
1. Select the LSB, USB, AM, or FM mode using the front
panel
[
MODE
]
selector buttons.
2. Press the front panel’s
[
BK-IN
]
button.
3. Press the FH-2’s
[
1
]
~
[
5
]
key, depending on which
memory register’s message you wish to transmit. If you
hit the key again during playback, the message will be
terminated.
LOCK
OFFON
ADVICE:
You may adjust the transmit (audio) level of the recording
via Menu item “017 dUS TX LVL.”
To Next Page
Loading...
Need help?
General
