VR-160 OPERATING MANUAL 9
LOCK
UNLOCK
Small Stud
Do not break this
Battery Terminal
INSTALLATION OF ACCESSORIES
INSTALLATION OF FNB-82LI BATTERY PACK
The FNB-82LI is a high-performance Lithium-Ion battery providing high capacity in a
very compact package. Under normal use, the FNB-82LI may be used for approximately
300 charge cycles, after which operating time may be expected to decrease. If you have an
older battery that is displaying diminished capacity, you should replace the pack with a
new one. Installation of the battery is easy and quick:
1. Slide the Battery Cover
Latch to the Unlock posi-
tion and then slide the Bat-
tery Cover toward the bot-
tom to remove it.
2. Install the FNB-82LI into
the Battery Compartment.
3. Replace the Battery Cover
and then slide the Battery
Cover Latch into the
“Lock” position.
Important Note:
There is a small stud in the Battery Compartment of the VR-160. This stud is a switch
for the battery detection. Please be careful not to break this stud while changing the
battery.
CAUTION
Risk of explosion if battery is replaced by incorrect type. Dispose of used batteries
according to the instructions.
Do not expose the Battery Pack to excessive heat such as direct sunshine, fire, or the
like.
Perform the battery charging when the ambient temperature range is +5 °C to +35 °C.
Charging out of this range could cause damage to the battery pack.
Use only the Vertex Standard Co., Ltd. Model PA-46C/U AC Adapter.
IMPORTANT NOTE
Always use the Vertex Standard Co., Ltd. Model FNB-82LI Battery Pack.
To Next Page
Loading...
Need help?
General
