VR-160 OPERATING MANUAL48
MEMORY SCANNING
Memory scanning is also easy to initiate:
1. Set the radio to the Memory mode by pressing the
[
V/M
]
key, if necessary.
2. Press and hold in the SCAN switch for one second until the
Memory Scan mode appears on the display.
3. Rotate the DIAL knob to select the desired Memory Scan mode.
Available selections are ALL CH, TAG1, TAG2, BAND, and PMS-
X.
ALL CH: The scanner sweeps all Memory channels.
TAG1: The scanner sweeps only those Memory channels with the same first digit of
the alpha/numeric tag as the first channel on which scanning started.
TAG2: The scanner sweeps only those Memory channels with the same first and
second digits of the alpha/numeric tag as the first channel on which scanning
started.
BAND: The scanner sweeps only those Memory channels which are memorized on
the same operating band as the first channel on which scanning started.
PMS-X: The scanner will sweep frequencies within the currently-selected PMS fre-
quency pair. See page 52 for details.
Note: Do not forget to pull the DIAL knob to rotate the DIAL knob.
3. Press the SCAN switch briefly to initiate scanning.
4. As with VFO scanning, the scanner will halt on any signal en-
countered that is strong enough to open the squelch; it will then
resume scanning according to the Scan-Resume mode set previ-
ously. When there are no memory channels corresponding to the
selected Memory Scan mode, the “MS ERR” notation will appear on the display.
5. To cancel scanning, press the SCAN switch or
[
V/M
]
key.
SCANNING
To Next Page
Loading...
Need help?
General
