VR-160 OPERATING MANUAL 89
APPENDIX
LINE-IN AUDIO CONNECTIONS
The VR-160 allows connecting the audio signal from the external audio equipment such as
an iPod
®
to an ACC Jack. If you engage the AF-DUAL function, you may monitor the
amateur radio signal while listening to your favorite music, for example.
1. Press and hold in the
[
BANK
]
key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 01: ACC SE-
LECT.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the
[
BANK
]
key briefly to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select “LINE IN”.
5. When you have made your selection, press and hold in the
[
BANK
]
key for one second to save the setting and exit to normal operation.
When the ACC Jack configuration is set to “LINE IN”, the “ ” icon
will appear at the upper right corner of the display.
Refer to the illustration below, connect the external audio equipment
to the ACC Jack using the after-market 3.5-mm to 3.5-mm stereo
cable.
External Audio Equipment
EXT SP Jack
After-Market Audio Connection Cable
(3.5-mm Stereo Plug on both ends)
To Next Page
Loading...
Need help?
General
