VR-160 OPERATING MANUAL16
AM AND FM BROADCAST RECEPTION
The VR-160 includes provision for reception of AM and FM broadcasts. FM broadcast
reception, utilizes a wide-bandwidth filter and stereo decoder which provides excellent
fidelity.
1. Press the
[
RADIO
]
key briefly to enter the Broadcast Re-
ception mode.
2. Press the
[
BAND
]
key to toggle the receiving band between
“AM broadcast” and “FM broadcast”.
The AM broadcast coverage is 504 to 1791 kHz and uti-
lizes AM mode. The “
[
A
]
” notation (which means AM) ap-
pears on the top of the display and an “AM” icon appears
on the bottom left of the display.
The FM broadcast coverage is 76.00 to 107.90 MHz and
utilizes Wide-FM mode. The “
[
F
]
” notation (which means
FM) appears on the top of the display and “WFM” icon
appears on the bottom left of the display.
3. Rotate the DIAL knob to select the desired station. When receiv-
ing an FM stereo signal, “ “ icon will appear at the bottom
left of the display.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
4. Press and hold the
[
RADIO
]
key for one second to enable the
antenna selection to be used by rotating the DIAL knob. Avail-
able selections are:
AM:“BAR ANTENNA” (Uses the internal Bar Antenna) or “BAR+EXT ANT” (Uses
both the internal Bar Antenna and the Rubber Flex Antenna).
FM:“EXT ANTENNA” (Uses the Rubber Flex Antenna) or “EARPHONE ANT” (Uses
the Earphone Antenna).
5. When you finish the selection, press the
[
RADIO
]
key briefly to exit from the antenna
selection mode.
6. Press the
[
RADIO
]
key briefly again to exit from the AM and FM Broadcast Recep-
tion mode and return to normal operation.
If you wish to output the audio of the FM Broadcast station to the VR-160
internal speaker while using the earphone antenna, select Set Mode Item 48:
SPEAKER OUT to “SPEAKER”.
OPERATION
To Next Page
Loading...
Need help?
General
