VR-160 OPERATING MANUAL88
APPENDIX
EXTERNAL AM RADIO ANTENNA CONNECTIONS
The VR-160 allows connecting an external antenna to an ACC Jack. Connecting a user
constructed or aftermarket antenna may provide superior AM band sensitivity and recep-
tion.
1. Press and hold in the
[
BANK
]
key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 01: ACC SE-
LECT.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the
[
BANK
]
key briefly to enable adjustment of this Set
Mode Item.
4. Rotate the DIAL knob to select “AM ANTENNA”.
5. Press the
[
BANK
]
key briefly to save the setting, then rotate the
DIAL knob to select Set Mode Item 03: ANTENNA AM.
6. Press the
[
BANK
]
key briefly, then rotate the DIAL knob to se-
lect “BAR+EXT ANT”.
7. When you have made your selection, press and hold in the
[
BANK
]
key for one second to save the setting and exit to nor-
mal operation.
When the ACC Jack configuration is set to “AM ANTENNA”, the
“ ” icon will appear at the upper right corner of the display.
Refer to the illustration below, and connect the user constructed or
an after-market antenna to the ACC Jack using the 3.5-mm stereo
plug (not supplied).
The antenna which connected to the ACC Jack works only in the AM Broad-
cast band (504 to 1791 kHz).
External Antenna
3.5-mm Stereo Jack
To Next Page
Loading...
Need help?
General
